CEM MAS7000 Microwave Ashing Oven- Reconditioned


  • CEM MAS7000 Microwave Ashing Oven- Reconditioned
  • With built-in serial and parallel ports
  • Can easily be transformed into a complete centre to ash and weigh samples
  • Requires no exhaust hood and can be used virtually anywhere
  • Reduction of large volumes by evaporation can be achieved in minutes rather than hours
  • Improve process control
  • Increase profits
  • Durable construction
  • Complies with AOAC Official Methods
  • Precise measurement of liquids, solids, slurries, fat (when used with CEM Fat Extractor), High volatiles Dilution, total suspended solids (TSS) and bias Syringe weighing
  • Printer Interface: 25-pin parallel
  • Languages: English


  • Temperature Capabilities: 1000C +/- 3C; 1200C +/- 3C (limited lifespan of furnace insulation when operated at 1200C)
  • Voltage selection switch permits electrical voltage to be switched from 208/230V or 220/240V
  • Power Output: 1400 watt magnetron with a power output of 900 watts minimum (at nominal line voltage)
  • Magnetron Frequency: 2455MHz
  • Exhaust Capabilities: 100 CFM
  • Printer Port: 25-Pin Parallel (System compatible with IBM, Espon, Okidata, ASCII, Star NX-1020 and HP Thinkjet printer)
  • Computer Interface: RS-232 Serial Interface (PC software to interface and collect data- must be supplies by the user)
  • Balance Interface: RS-232, Serial Interface
  • Furnace Chamber Volume: 112.5 in^3 (1.8 liters)
  • IR Detection System: Infrared detection device fro door protection
  • Internal Calibration of Temperature Control: Calibrated to NIST Traceable Standard
  • Internal Diagnostic Software: BITS System (Built-in Test System) Analyzes magnetron hrs. system power on hrs, time spent on various temperatures, number of door openings and classing, calibration time and date calibration set points, calibration tables and data.
  • Safety Interlock: Three safety interlock mechanisms prevent instrument operation and microwave emissions in case of improper door closure or misalignment

Electrical Requirement:

208/230 VAC, 60 Hz, 10 amps / 220/240 VAC, 50 Hz, 10 amps

Overall Instrument Dimensions:

18.17 25.75 x 19.60in. (WxDxH) / 46.15 x 65.40 x 49.78 (WxDxH)

Furnace Chamber Dimensions:

8.25 x 4.55 x 3.00 (WxDxH) / 20.96 x 11.56 x 7.62 (WxDxH)

Unit Weight:

97.5 lbs. / 44.226kg

CEM MAS7000, CEM MAS 7000, MAS7000, MAS 7000, CEM MAS-7000, MAS-7000 are registered trademarks of CEM Corporation.

Instruments listed above are registered trademark of their respective corporation.

Add to Cart:

  • Model: MAS7000
  • Shipping Weight: 100lbs
  • Manufactured by: CEM Corporation

This product was added to our catalog on Wednesday 06 July, 2011.

Copyright © 2017 Laboratory Instrument Specialists. Powered by Zen Cart