Omnimark uWave Microwave Moisture/Solid Analyzer Reconditioned

$12,500.00

We carry Omnimark Instrument uWave microwave moisture analyzers with uWave technology for faster and reliable results.

Description:

  • Omnimark uWave microwave moisture analyzer
  • Indoor Use Only
  • The Omnimark uWave is a rapid moisture determination system it specializes in high moisture
  • Quick Moisture/Solid Analyzer
  • Many samples yield results in less than 1 minute!
  • Improved process control
  • Saves time and money
  • Incorporates new, patented microwave technology
  • Microwave chamber is small and cylindrical
  • Energy is focused on the sample
  • Sensor technology determines when water is fully liberated
  • Low power consumption; no charring of the sample
  • Easy to use
  • Simple key stroke to test a sample
  • Automatic weight capture of initial and final weight
  • One-step recall of up to 30 customizable programs

Specifications:

  • Measurement method: Microwave radiation and detection of weight loss
  • Power setting: 30-100% of 450 watts
  • Balance capacity: 30 grams
  • Balance readability: 0.1 mg
  • Readability of result: 0.01%
  • Working range: 10-100% Moisture
  • Units of results: Percent moisture, solids, volatiles, mg/L, weight loss and custom
  • End of analysis modes: Time-out or custom slope with sensor
  • Display: 5.9 VGA resolution backlit liquid crystal display (LCD) (320 X 240 dots)
  • Controls: Test, Enter, 4 arrows, 4 softkeys and numeric keypad with decimal and +/- keys
  • Program storage: 30 drying procedures with alphanumeric naming
  • Data storage: 495 last results with statistical evaluation
  • Integral printer: Thermal, graphical 500 dots per line
  • External I/O: One serial bi-directional and one serial uni-directional RS232
  • Class I Equipment (grounded)
  • Mains supply voltage should not exceed +10% of the nominal supply voltage
  • Sound Pressure: <70 dBA
  • Operating Temp Range: 15C - 40C
  • Recommended Altitude: <3000 M
  • Operating Humidity: 80% for temperatures to 31C, decreasing linearly to 50% relative humidity at 40C
  • Pollution Degree: 2
  • Installation Category: II for transient voltages

Electrical Requirement:

  • Input power requirements: 100V, 50/60 Hz, 550W, 10 Amps / 120V, 60 Hz, 550W, 10 Amps

Omnimark uWave, Omnimark-uWave, Omnimark u Wave, uWave, Omnimark u-Wave

Instruments listed above are registered trademark of their respective corporation.


Add to Cart:

  • Model: uWave
  • Shipping Weight: 100lbs
  • Manufactured by: Omnimark Corporation


This product was added to our catalog on Wednesday 03 September, 2008.

Copyright © 2017 Laboratory Instrument Specialists. Powered by Zen Cart